Welcome to Dongguan Qunhui Machine Tool Protection Technology Company!
TEL: 0769-81128827 | Mobile version
  • Steel protective cover
  • Organ Protective Cover
  • Machine tool cover
    Machine tool cover Stainless steel plate protective cover

    protecting mask

    • Detailed introduction
    Brand: Qunhui model: QH
    style: Steel protective cover Stretched length: Customized (mm)
    Compressed length: Customized (mm) Stroke length: Customized (mm)
    Overall hood width: According to customer requirements (mm) Protected parts: Lead screw
    Applicable machine tools: Machining Center Whether inventory: no

    The steel machine tool guide guard is a traditional form of protection for machine tools. In this field, the steel telescopic guide shield is widely used, which plays an effective role in preventing the entry of chips and other sharp objects. Through certain structural measures and suitable scraping plates, the cooling can also be effectively reduced. Infiltration of fluid. The steel telescopic guide shield of our factory can meet the increasing requirements of modern machine tools for high technology, correct installation position and high running speed.

    Steel plate protective cover is generally made of high-quality 2-3mm thick steel plate by cold pressing. Stainless steel can also be selected according to requirements. Our company can provide corresponding guide rail protection types for all machine tools (horizontal, vertical, inclined, horizontal) . The number of sections of the steel shield is important for its proportion, weight, and operating characteristics.
       The number of sections of the steel telescopic rail shield is important for its proportion, weight and operating characteristics. Each single section should be as long as possible, which can reduce the number of sections and reduce costs. In general, the maximum stretch and minimum compression ratio should be between 3: 1 and 5: 1 (up to 10: 1). According to different running speeds and guide rails, the protective cover structure we developed is also different. Below 10m / min, we are equipped with polyurethane brass sliders. It is equipped with rollers at a medium speed of 30m / min. In addition, a buffer system is needed between the driving plate, the scraping plate and the suction plate. If the running speed is higher, the two sides can discuss the special design. The purpose of the slider system is to reduce collision, noise and friction.

    Material of stainless steel shield :
    The real 1Cr13 stainless steel plate is used as the main material, and other connecting plates and follower hanging bars are made of stainless steel. It has the characteristics of large bearing capacity, corrosion resistance to acid and alkali, no rust, high temperature resistance, and long life.
    1. Hard objects will not deform when colliding, long life, good sealing, and light operation.
    2. Long stroke and small compression.
    3. Resistant to coolant, oil, water, acid, sand wheel foam and iron filings.
    4, sturdy and durable, stable operation, low noise, beautiful appearance.
    5, suitable for high-speed motion machine tool guide protection is both stable and no vibration noise.
    6. It not only protects the service life of the guard plate, but also ensures the precision of the machine tool.
    7. Each section of the guard plate is pulled apart in parallel and retracted in parallel at the same time, and it runs freely.
    8. It will not make the guard plate disjointed and there will be impact sound, which is both beautiful and improves the service life of the guard plate.
    9. A layer of stainless steel cover is added on the basis of the original sealing strip to prevent high-temperature burns of iron filings from rubbing into the rail surface to damage the guide rail.
    • Click here to send me a message
    • Click here to send me a message
    • Click here to send me a message